CH and HW problem

Russell

Guest

Posts: n/a

08-19-2003, 04:02 PM

My system has gone bananas. I have a Potterton Kingfisher 2 boiler,
which fires up for about a minute, with higher than normal flue gas
teperatures. The pump does not run unless I push the motorised valve
(2 port) round with a screwdriver to operate the microswitch. Can
anyone tell me where to start checking for the fault? When the pump is
running it makes a sound like the water is cavitating within if that
gives any clues.

Thanks

« Re: Wanted: Advice on Garage Racking | Re: removing skirting 'neatly' ! »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Diverter valve problem fixed but now another problem.	dave	UK DIY	9	01-06-2006 03:18 PM
Roof Problem - Major or Minor Problem?	Patrick	Roofing	10	03-27-2005 09:30 PM
Septic system problem-pump out or drain field problem?	Arthur Davis	Home Repair	1	01-09-2005 11:16 PM
Chicken-and-Egg Problem: Whirlpool Deck Tile and Faucets	Al Barnhard	Building Construction	4	11-03-2003 02:30 PM
Re: groundhog problem(?) [Was: Skunk Problem]	Tom Miller	Home Repair	1	08-10-2003 09:51 PM

All times are GMT. The time now is 06:20 PM.